DA Mamba (T15) Magwell - M17

***SkunkWorks Item, in development, please see SkunkWorks page for details***

 This is the Digital Armory downloadable design. You will not be shipped a physical product. You must print this item yourself.

Utilize T15 V1 or V2 magazines in your Milsig M17 marker. This magwell uses "ball on deck" system to make up for the collarless mag on the M17 which was designed to use collared mags. This means the last ball in each mag will not feed into the chamber, and instead be held in place by a rubber detent during mag changes. To prevent FSR flips during mag changes, it is recommended to load the FIRST two rounds in every mag as tough shelled regular paintballs (in other words, those two rounds will feed LAST). If all goes well, you'll also know when your mag is empty because the last round fired will be a regular paintball.

The magcatch is fully ambidextrous, allowing you to use either trigger finger. 

You will still need to give the mags a firm insertion and/or a quick love tap to get the nice "click" into place.

Recommended to use the newer V2 T15 mags. V1 will fit, but be VERY tight, and probably need some filing of the spine inside the magwell. No modding of the mags is required.

Includes:

• T15 Magwell
• M17 Feedneck Adapter
• Ball Rentention Detent
• Magcatch

Requires

• Milsig M17A2/CQC/PMC
• First Strike T15 magazines
• 3D Printer
• M2.5x25mm machine screw
• 6mm wide x 13mm long stiff spring (pen spring might work)
• Ball Rentention Detents must be printed using flexible material

***SkunkWorks Item, in development, please see SkunkWorks page for details***